Electronics Tray for Axial 1/18 Capra UTB18 using Hobbywing 1080
SKU:
$35.00
$32.50 - $35.00
per item
These parts are made from Nylon PA12, printed on an industrial MJF printer, then if you choose, professionally dyed black.
- Specifically designed to fit a Hobbywing 1080 Crawler ESC, but also compatible with similar sized ESCs
- Replaces the stock back cage section
- Provides a flat surface to mount your receiver, etc
Only a few left!
Moderately Easy to install:
- Remove the 4 screws for the upper shock mounts, and 4 screws for the skid plate in order to remove the cage from the drivetrain
- Remove 11 screws to remove existing electronics tray and fuel cell
- Install the ESC into the tray, and secure the power button/switch to the back of the tray with double sided tape
- Tip: there are 2 zip tie slots provided so you can secure the wire for the power switch or lights
- Reinstall the new tray into the cage.
- Run the light bar wires through the clips on one side, and the antenna wire can be run through the added clips on the other side of the cage.